Bottled Water Cooler Specifications
-
Cabinet: All corrosion-resistant stainless
steel type-316L, inside and outside including interior shelves, mountings and
drip basin. Satin finish on all exterior surfaces for an attractive and
easily-cleaned lustrous appearance. Bottle-support ring made of durable and
corrosion-resistant polypropylene.
- Valves: Self-closing, no-drip cup filler.
Made from durable and corrosion-resistant polypropylene.
- Cold Water Reservoir: Flat-bottom stainless
steel basin with approximately 2-1/2 quarts (2.4 liters) useable capacity and
polypropylene fittings. Corrosion-protected copper evaporator coil is wrapped
around reservoir, insulated with closed-cell elastomer and bonded to basin
with thermal mastic.
- Corrosion Protection: Capillary tube,
sight glass, filter-dryer, two access valves and all metal tubing protected
by coating of high-solids special low-porosity epoxy applied by immersing
assemblies in an electrostatically-charged bath and cured by baking in an
oven to protect them from acidic, caustic, saline, and other types of
corrosion.
- Condenser:
Triple layer and sized for high
ambient temperatures and high altitudes, and protected against acidic and
other corrosion with a special epoxy coating (e-coat) with near-zero porosity
applied electrostatically and oven cured.
- Compressor:
Andover Protection Systems’ Model EEG
(for 115/60/1) or APS Model EEJ (220-240/50-60/1). These compressors are
specifically designed for use in harsh or harsh and hazardous conditions.
- Capacity:
- Rated Capacity: At water and air
temperature of 131º F (55C)— lower 0.5 gallon (1.9 liters) per hour of water from 131ºF
(55C) to 50ºF (10C) – Note: 131ºF water will scald skin; therefore, chiller
must lower the water 81ºF (27C) degrees to reach the standard chilled-water
temperature of 50ºF (10C).
- Capacity at ARI standard conditions:
water and air temperature of 90ºF (32.2C)—lower 0.9 gallons (3.4 liters) per hour of
water from 90ºF (32.2C) to 50ºF (10C) -- (50% more cold water than standard
units)
- ADA: Overall, the coolers comply
with the requirements of the
ADA specification
4.15.2-4
- Shipping Dimensions: Approximately 80
pounds
and 6.5 cubic feet.
- Hazardous-Duty: When specified, BSDE makes the units suitable for hazardous-duty
("explosion-proof") conditions. It will use UL-recognized hazardous-duty
compressors appropriate for the classification of the area. BSDE offers
bottled-water coolers suitable for use in areas classified for any of the
following types of locations: Class I, II, or III,
Groups B, C, D, E, F or G,
and Division/Zone 2 or 1. The units will be factory sealed for fast and easy
installation. The hazardous-duty units will have the standard harsh-duty
features of BSDE's standard coolers.
|
